- #Honda s2000 clutch oil change how to#
- #Honda s2000 clutch oil change drivers#
- #Honda s2000 clutch oil change manual#
The sharp edge should face the transmission. Usually the crush washer will have two sides, one that has a rounded edge and one that has a sharper edge.Replace the old crush washer from the transmission oil drain bolt.Wait until no oil (either old or new from "rinsing") comes out of the transmission.Once all the oil has be drained I like to fill fresh oil into the transmission to "rinse or flush" the transmission with the new oil.
You will notice that once the filling bolt is completely gone, more oil will come out of the transmission oil drain. The old transmission oil will now drain from the transmission and you might need to re-adjust your oil catch pan. Next remove the transmission oil drain bolt with a 17mm socket from the transmission. First remove the transmission oil filling bolt with a 17mm socket from the transmission. This ensures that the filling bolt is not stuck and prevents you from ending up with a drained transmission that you can't re-fill. It is a good idea to first remove the filling bolt and afterwards the draining bolt. Place your oil catch pan below the transmission drain bolt. The lower bolt is the drain bolt while the upper one is the filling bolt. #Honda s2000 clutch oil change drivers#
The transmission is located behind the engine and has two bolts (drain and filling) on the drivers side. Place your jack stands on the left and right side jacking points at the rear of the car. Lower and remove your floor jack and continue jacking up the rear by using the jacking point on the differential. Place one jack stand on each side at the jacking-point that is the furthest away from the front wheel. There are two front-jacking-points on each side. Jack up the car on the front by using the central jacking point near the engine. Put the car in the first gear and set the parking brake. Before you start it might be a good idea to drive the car for a while to increase the temperature of the oil in the transmission. #Honda s2000 clutch oil change how to#
How to change the transmission oil Pre-conditions and jacking up the car
A lube pump since it is hard to fill the transmission without it. Torque wrench (40Nm / 29 lb-ft and 44Nm / 33 lb-ft). New crush washer for the oil filling bolt (Honda #91409-20000 / 20/x/Aluminium / See: Washer#Transmission_oil_filling_bolt). New crush washer for the oil drain bolt (Honda #91409-14000 / 14/24/Aluminium / See: Washer#Transmission_oil_drain_bolt). 1,6L/1,6qts transmission oil (or a little more if you would like to "flush" the transmission). See: Transmission oil recommendations Required tools and fluids Racetrack driving (most people recommend to change the oil after each racetrack visit). 
Long periods of driving at 150km/h (93 mph) or above. Sport and fast paced driving with a lot of VTEC engagement. as taxi or commercial deliver vehicle).Īdditionally definition from other S2000 owners: Extensive idling or long periods of stop-and-go driving (e.g. In hot weather climates with temperatures above 32☌/90☏. Less than 16km (10m miles) per trip on freezing temperatures. Less than 8km (5 miles) per trip on non-freezing weather conditions. #Honda s2000 clutch oil change manual#
The service manual states the following definition: Harsh driving conditions: Every 48.000km / 30.000miles or 6 months (which ever comes first)ĭefinition of harsh driving conditions.Normal driving conditions: Every 144.000km / 90.000miles or 6 years (which ever comes first).The owners and service manual recommends the following intervals: 5 How to make sure no old transmission oil is left in the transmission.4.1 Pre-conditions and jacking up the car.
1.1 Definition of harsh driving conditions.
0 kommentar(er)
